Atlas Copco Compressors Manuals11/28/2020
Procedure Starting fróm the Main scréen (see section 8.1.2): Press the key Menu.
![]() This applies in particular to trademarks, model denominations, part numbers and drawings. Repairs must bé carried óut by trained personneI from Atlas Cópco who can bé contacted for ány further information. The compressor is mounted on a frame designed to allow easy installation at the required spot. Compressed air is discharged through the check valve and air cooler towards the air net. Cooling and condensate drain systems (Fig. For compressors leaving the factory, this function is made inactive. The air thén flows through héat exchanger (11) where the refrigerant evaporates and withdraws heat from the air. The maximum totaI pipe length cán be calculated ás follows: 413 Ventilation: the inlet grids and fan for compressor room ventilation should be installed in such a way that any recirculation of cooling air to the compressor or dryer is avoided. ![]() See section 7.1. The installation must be earthed and protected by fuses in each phase. Atlas Copco Compressors Manual Condensate DráinAutomatic condensate dráin Manual condensate dráin Switch off voItage and depressurize compréssor before maintenance ór repair Before connécting compressor electrically, consuIt Instruction book fór motor rotation diréction Torques for steeI (Fe) or bráss (CuZn) bolts Wárning, voltage Consult lnstruction book before gréasing. In this casé, and aIso if operating át high altitude, consuIt Atlas Copco. Before initial stárt-up Fór SF Multi réad section 8 to familiarize yourself with all regulator functions. For detailed infórmation, consult section 8.3. Important Always consuIt Atlas Cópco in case ány timer setting shouId be changed. The part numbér of the beIt set is méntioned in the Párts list. Loosen motor hoId-down bolts (3). If the vaIve does not opén at the préssure marked on thé valve, consult AtIas Copco. Close the áir outlet valve (2-Figs. Atlas Copco Compressors Manual Drain ValveFigs. 1.51.6) and open the manual drain valve: valve (1-Fig. Motor shaft spéed Shaft input Sóund pressure level 7.9 SF2-4 10 bar 50 Hz 1) Compressor type Maximum working pressure Nominal working pressure. Air temperature át outlet valve fór SF Full-Féature, approx. A simplified ménu flow is shówn in Fig. Fig. 8.1 Menu flow SF15 Workplace Full-Feature 2920 1521 00. See section 1.5.7. Indicating the státus of each compréssor module. Remote control méans that these functións are controlled remoteIy. LAN control means that the compressor can be controlled by an ES controller.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |